PVC Fencing
Springwood.
4127
Logan City's principal activity centre on the Pacific Motorway, twenty kilometres south of Brisbane, where 1970s and 1980s housing now sits among contemporary infill.
Springwood
Springwood was developed in the late 1970s and early 1980s alongside the construction of the South East Freeway, which was completed in 1985. The suburb's original housing pattern was laid out as a fast-build commuter belt feeding the new motorway, predominantly brick-and-tile homes on conventionally serviced lots. Since the 2000s, Logan City Council has redesignated Springwood as a Principal Activity Centre and the suburb has been steadily reshaped: Springwood Mall and the surrounding commercial precinct intensified, residential streets infilled with townhouses and unit blocks, and the original 1980s housing stock has begun an extended fence-replacement cycle as the first generation of treated-pine palings and steel sheet fences reach the end of their service lives. Springwood sits inside Logan City Council, not Brisbane City Council, which means the planning instrument is the Logan Planning Scheme 2015 rather than the Brisbane City Plan 2014.
Springwood streetscape
How Springwood fences.
Location & era
Springwood covers postcode 4127 and sits about twenty kilometres south of the Brisbane CBD across roughly 5 square kilometres, immediately adjacent to the Pacific Motorway. The dominant housing era is late 1970s through the 1980s: brick-veneer-and-tile homes on slabs, typically on lots of 600 to 800 square metres with consistent setbacks and rectangular shapes.
Terrain & infill
The terrain is moderately undulating rather than steep. The original subdivision design followed the natural contour to a reasonable degree, so most blocks have a manageable cross-fall rather than the aggressive slopes that define Mount Gravatt. Through the 1990s and 2000s a layer of two-storey rebuilds and townhouse infill was added, particularly on streets closer to the motorway and the commercial centre.
The common job
The original fencing on the 1980s stock split between treated-pine paling on the front and side returns and Colorbond steel on the rear and long sides. Forty years on, both types are reaching the typical failure points: paling rotting at the rails and at the ground, steel corroding at the base. The rebuild specification is now consistently a PVC privacy panel that does not need painting and does not corrode at ground contact.
PVC fencing considerations for Springwood
Logan, not Brisbane
Springwood is governed by Logan City Council under the Logan Planning Scheme 2015, not the Brisbane City Plan 2014. The accepted-development limits for dividing fences are broadly similar: fences up to 2 metres on side and rear boundaries generally do not require a development application, but the specific code paths and overlays differ from Brisbane. Anything above 2 metres requires a building certifier under the Queensland Building Act 1975, the statewide instrument that applies across Queensland regardless of council.
Cost-sharing
Dividing-fence cost sharing falls under the Neighbourhood Disputes (Dividing Fences and Trees) Act 2011 (Qld). The same act applies on both sides of the Brisbane to Logan boundary, so the cost-allocation process for a shared rebuild is identical to the inner-Brisbane suburbs.
Front-fence freedom
Springwood is not blanketed by a character overlay equivalent to Brisbane's pre-1947 protection, because the suburb's housing era is too recent for that to apply, so front-fence specification has substantially more freedom than in inner-Brisbane character suburbs. The Ascot 1.8m full-privacy panel is the most common rebuild specification on long sides and rear boundaries; the Henley range is the most common picket frontage choice where the original 1980s timber paling front fence is being replaced rather than removed.
Pool safety
Pool fencing must comply with AS 1926.1-2012, with the 900mm non-climbable zone measured from finished ground.
The Collection
Five ranges, delivered to Springwood.
Every PVC fencing range is available in Springwood — supply only, or supply and install. Every price includes GST.
Henley
Picket Fencing
From $166.54 per set
From $166.54 per set
Oxford
Semi-Privacy Fencing
From $266.46 per set
From $266.46 per set
Eton
Closed-Top Fencing
From $273.11 per set
From $273.11 per set
Ascot
Full Privacy Fencing
From $254.54 per set
From $254.54 per set
Cotswold
Horse & Farm Fencing
From $92.05 per set
From $92.05 per set
Delivery
Delivered to Springwood.
We deliver PVC fencing to Springwood and every other Brisbane suburb. Each order is palletised for safe transit and needs someone on site to receive it.
- Estimated delivery
- 3-5 business days metro, 5-7 days outer suburbs
Pricing
Pricing for Springwood.
Prices are identical across every Brisbane suburb — there is no location surcharge for Springwood. What you see online is what you pay, GST included.
Questions
PVC fencing Springwood, answered.
- Springwood is in Logan City Council, not Brisbane. Do the fence rules change?
- The underlying state framework is the same: the Neighbourhood Disputes (Dividing Fences and Trees) Act 2011 governs cost sharing across all Queensland local government areas, AS 1926.1-2012 sets pool fencing standards statewide, and the Queensland Building Act 1975 requires certification for fences above 2 metres regardless of council. What changes is the planning instrument: Logan City Council uses the Logan Planning Scheme 2015 rather than the Brisbane City Plan 2014. Accepted-development limits for typical residential boundary fencing are broadly comparable, but the specific code paths and any locality plans or overlays affecting your block are Logan-specific. For an unusual project, check the Logan PD Hub interactive mapping or call Logan City Council before ordering.
- Our 1980s treated-pine paling is failing. Is rebuilding in treated pine cheaper than going to PVC?
- Like-for-like timber paling looks cheaper upfront. The genuine total-cost picture over a 25-year window is different: a treated-pine paling fence in Springwood's climate typically needs two repaint or restain cycles and one rail or post replacement to make it that far, and many fail entirely well short of 25 years. PVC has none of those costs: no paint cycle, no rail replacement, no rot at the ground line. The crossover usually arrives between year 12 and year 15. If you are planning to be in the house long-term, the cumulative spend favours PVC by a meaningful margin. If you are selling within five years, treated pine may make sense.
- We back onto the Pacific Motorway buffer. Will a PVC fence reduce road noise?
- Solid PVC privacy panels like the Ascot 2.1m or 2.4m provide some noise reduction (typically 5 to 10 decibels for steady-state traffic), which is a noticeable improvement on a paling fence with gaps or a Colorbond steel sheet that resonates with engine noise. The benefit is meaningful but bounded; a privacy fence is not an acoustic wall, and for properties immediately on the motorway corridor the step change in lived-in noise comes from window glazing and wall insulation rather than fence specification. The 2.4m Ascot includes a structural mid-rail that improves wind-load performance, which matters on the open western exposure that motorway-adjacent Springwood blocks tend to have.
- Our block has a noticeable cross-fall to the rear. Same fence specification as a flat block?
- The panel and post specification is the same; the install pattern is different. On a sloped Springwood block the run is broken into stepped panels rather than installed as a continuous level line. Each 2.44m panel drops independently with the grade, the posts stay plumb, and the run reads as a deliberate set of steps. The choice is between a step-down install (visually cleaner, slightly more bottom-rail trim required where the gap to ground widens) and a sloped or 'raked' install where the panels follow the slope continuously. The stepped install is the standard answer for residential boundaries because it looks more deliberate and the panel construction was designed for it.
- Our 1980s pool barrier doesn't meet current standards. Is the boundary fence rebuild the right time to fix it?
- Yes. Combining the two jobs is more efficient and gives you a clean compliance position. The current pool barrier standard is AS 1926.1-2012, which sets the 1.2m minimum effective height, the 900mm non-climbable zone outside the barrier, and the no-climbable-footholds rule within the climb zone. If your 1980s barrier was built to the standard of the day, it almost certainly does not meet current rules. A rebuild that integrates the boundary fence with a compliant pool barrier, either as a shared run where the geometry allows, or as two separate compliant runs where the pool sits inside the boundary, closes the compliance gap and avoids the cost of touching the same line twice.
Nearby
Nearby in Brisbane.
Ready when you are
Get PVC fencing in Springwood.
Draw your fence on a map of your Springwood property and see every panel, post, and cap priced line by line before you spend a cent.